Today is another technique using the Ranger Colour wash inks. Here is what your finished piece will look something like. Remember this will give you a unique piece every time you do it so results will naturally vary.
**Please note the following cautions to prevent damaging your soft furnishings**
Please be aware that this ink will stain whatever it comes into contact with. So it is best not to do this over carpet, near wall paper or curtains. The kitchen is a good place if you don’t have a dedicated studio space.
You will need
- Ranger Colourwash Spray ink. Three colours of your choice for this project. (Sell whatever you have to, and buy them all they are fabulous) Disposable gloves; the cheapest going is fine. You really need these!
A large empty, no longer required cardboard box/plastic box.
- Blank newsprint; available in large sheets from removal companies; I got 500 A2 sheets for £12
- A couple of bin liners
- Watercolour paper, I used 280 gsm NOT paper. (The NOT in this case refers to not put through rollers, so the paper has a texture rather than being totally smooth.
- Heat Resistant Surface
- Heat tool
This is truly messy and best done over a hard floor just in case some ink goes astray. Don’t do this for the first time near wallpaper or curtains!
1. Cover your entire workspace with at least two layers of blank newsprint OR cut open your bin liner and use this to cover your working area.
2. If you need more drying space than your table allows for, cut open a couple of bin liners and place them on the floor.
3. Place your cardboard box on your table; you will be spraying the ink into this box.
4. Arrange your inks on you now waterproof surface. Ready to go.
5. PUT THE GLOVES ON!! Don’t think this is being OTT this is dye ink and will stain your hands for DAYS!
6. Place a sheet of folded up blank newsprint in the base of your box, this will catch any overspray.
7. Place your sheet of printer paper in the bottom of the box.
8. Choose three colours of ink that you like and remove their lids.
9. Spray the inks over the paper, start with the lightest and work down to the darkest.
10. Don’t be afraid of the ink, get the paper well covered and don’t forget the edges.
11. Now spray your card heavily with plain water. Really go for it and you will have droplets of ink sitting on top of your card.
12. Carefully take your card out of the box and place it on a heat proof surface
13. Using your heat tool slowly dry your card. Hold the heat tool quite high to start with otherwise you will chase your droplets around your card, this is fine when you want to experiment but will not give you the spotted mottled effect which this is aiming for.
Tips and options
If you find your card is warping too much then on another attempt tape your card to something before you spray it.
Hold the heat tool closer to the work and DO chase the droplets around, have fun see what happens.
The beadie eyed amongst you will have noticed that for steps 9 & 10 I have used pics from earlier in the week. This is just because other than the change to heavier paper the start of this techninque is the same. Hope you don’t mind tooo much😉 about the duplication of the pictures.
I do have one more paper colouring technique to show you but that will be a little time in coming. I have to admit that these tutorials were until this one, shown on my older blog. Producing these tutorials takes a week! I will continue to post tutorials but they will be a little less frequent as they take soo long to make. But good things are worth waiting for right??
If there is any particular technique or product that you would like to see a tutorial on do let me know using the comments box. If I get any requests and have the required knowledge or products I’ll see what I can do for you. I don’t bite and would be happy to hear what you think of all these things I post.
Best wishes and thanks for reading, see you next week